Related Questions

A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
A Architectural
B Civil
C Mechanical
D Process piping
A partial auxiliary view is used to show only the __________ in the auxiliary view.
A Projected inclined plane
B The projected top view
C The projected side view
D None of the above
In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
A Detail
B Title block
C Parts list
D Isometric
When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.
A Pull the line from away from the starting point very carefully
B Insure that Ortho is on
C Enter 3 for the length of the line
D Read the coordinate position on the Dynamic Readout
The lines used to create the auxiliary view should appear as ________ in the finished view.
A Object lines
B Construction lines
C Reference lines
D Construction lines
In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.
A Leave the view as is
B Eliminate the view
C Use the left view instead
D None of the above
By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
A Half
B Whole
C Revolved
D Broken out
In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct iso-plane has been selected by scrolling through the iso-planes using the ________ key.
A F1
B F3
C F5
D F8
A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
A Offset
B Half
C Whole
D Broken out
In order to create one solid model from two or more separate solid shapes the drafter will need to position them and then ________.
A Use Union to join them
B Use the Join command
C Use the Add Parts tool
D None of the above

Next steps