Related Questions

John, Jack, Joseph and Jordan participated in a running race. Only the winner finished the race in 10 minutes. Which two pieces of information can tell you who the winner was? (i) John finished the race in 16 minutes . (ii) Joseph finished the race earlier than Jack by 2 minutes. (iii) Jack finished the race later than Jordan by 4 minutes. (iv) Jordan finished the race earlier than John by 6 minutes. (v) John finished the race later than Joseph by minutes.
A I and II
B I and IV
C II and III
D II and V
A partial auxiliary view is used to show only the __________ in the auxiliary view.
A Projected inclined plane
B The projected top view
C The projected side view
D None of the above
When using the descriptive geometry method to create an auxiliary view the drafter should _________.
A Rotate the snap grid to the same angle of the inclined plane
B Offset the right vertical line of the front view
C Rotate the top line of the front view 45 degrees
D Offset the top line of the front view 2 inches
The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.
A Width
B Height
C Length
D None of the above
When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
A Linear dimension
B Aligned dimension
C Baseline dimension
D Angle dimension
The principle reason for using an auxiliary view is ________.
A To eliminate hidden lines
B To create a true projection plane from an inclined plane in one of the primary views
C To show cylinders as ellipses
D To locate center marks
P, Q, R are employed to do a work for Tk. 5,750. P and Q together finished 1923 of work and Q and R together finished 823 of work. Wage of Q, in Taka, is
A 1,000
In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
A Primary
B Secondary
C Revolved
D Partial
In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
A Detail
B Title block
C Parts list
D Isometric
A partial auxiliary view usually shows only features on the _________ of the inclined line and not any projection of other planes.
A Hidden lines
B Plane
C Center lines
D None of the above

Next steps