Related Questions

A partial auxiliary view is used to show only the __________ in the auxiliary view.
A Projected inclined plane
B The projected top view
C The projected side view
D None of the above
The lines used to create the auxiliary view should appear as ________ in the finished view.
A Object lines
B Construction lines
C Reference lines
D Construction lines
The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.
A Width
B Height
C Length
D None of the above
In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.
A Leave the view as is
B Eliminate the view
C Use the left view instead
D None of the above
A partial auxiliary view usually shows only features on the _________ of the inclined line and not any projection of other planes.
A Hidden lines
B Plane
C Center lines
D None of the above
This type of auxiliary view is projected onto a plane that is perpendicular to one of the principal planes of projection:
A Primary
B Secondary
C Revolved
D Successive
The Contour line is those imaginary line which show?
A Areas of similar atmospheric pressure
B Areas of similar temperature
C Areas of similar height
D Equal Sunning areas
In developing a multi-view drawing, the drafter can use a ________ line to help locate the top and right side views.
A Object
B Hidden
C Dimension
D Miter
A secondary auxiliary view is a projection off of the __________.
A Front view
B Top view
C Primary auxiliary view
D None of the above
When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
A Linear dimension
B Aligned dimension
C Baseline dimension
D Angle dimension

Next steps