Related Questions

A partial auxiliary view is used to show only the __________ in the auxiliary view.
A Projected inclined plane
B The projected top view
C The projected side view
D None of the above
The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.
A Width
B Height
C Length
D None of the above
The lines used to create the auxiliary view should appear as ________ in the finished view.
A Object lines
B Construction lines
C Reference lines
D Construction lines
The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.
A Linear
B Continue
C Baseline
D Quick Dimension
In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.
A Leave the view as is
B Eliminate the view
C Use the left view instead
D None of the above
The principle reason for using an auxiliary view is ________.
A To eliminate hidden lines
B To create a true projection plane from an inclined plane in one of the primary views
C To show cylinders as ellipses
D To locate center marks
A partial auxiliary view usually shows only features on the _________ of the inclined line and not any projection of other planes.
A Hidden lines
B Plane
C Center lines
D None of the above
In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
A Primary
B Secondary
C Revolved
D Partial
This type of auxiliary view is projected onto a plane that is perpendicular to one of the principal planes of projection:
A Primary
B Secondary
C Revolved
D Successive
A secondary auxiliary view is a projection off of the __________.
A Front view
B Top view
C Primary auxiliary view
D None of the above

Next steps