Related Questions

A partial auxiliary view is used to show only the __________ in the auxiliary view.
A Projected inclined plane
B The projected top view
C The projected side view
D None of the above
The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.
A Width
B Height
C Length
D None of the above
The lines used to create the auxiliary view should appear as ________ in the finished view.
A Object lines
B Construction lines
C Reference lines
D Construction lines
When using the descriptive geometry method to create an auxiliary view the drafter should _________.
A Rotate the snap grid to the same angle of the inclined plane
B Offset the right vertical line of the front view
C Rotate the top line of the front view 45 degrees
D Offset the top line of the front view 2 inches
When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
A Linear dimension
B Aligned dimension
C Baseline dimension
D Angle dimension
A partial auxiliary view usually shows only features on the _________ of the inclined line and not any projection of other planes.
A Hidden lines
B Plane
C Center lines
D None of the above
In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
A Primary
B Secondary
C Revolved
D Partial
This type of auxiliary view is projected onto a plane that is perpendicular to one of the principal planes of projection:
A Primary
B Secondary
C Revolved
D Successive
A secondary auxiliary view is a projection off of the __________.
A Front view
B Top view
C Primary auxiliary view
D None of the above
Drafters should use a ________ in a section view of a mechanical part that includes the cylindrical view of a threaded hole.
A Center line
B Hatch line
C Poly line
D Dimension line

Next steps