Related Questions

By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
A Half
B Whole
C Revolved
D Broken out
One critical issue drafters need to pay close attention to is the ________.
A Size of the sheet
B Designer's intent
C Scale factor
D None of the above
Traditional drafters need to be able to create several different line widths because ________.
A Different line widths convey different information
B The line width has to do with how dark it appear in the finished drawing
C They seem to transmit better in a fax machine
D It makes no difference
A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)
A $$\sigma \left( {1 + \frac{{\text{b}}}{{2{\text{a}}}}} \right)$$
B $$\sigma \left( {1 + \frac{{2{\text{a}}}}{{\text{b}}}} \right)$$
C $$\sigma \left( {1 + \frac{{\text{b}}}{{3{\text{a}}}}} \right)$$
D $$\sigma \left( {1 + \frac{{3{\text{a}}}}{{\text{b}}}} \right)$$
Who was one of the drafters of the Universal Declaration of Human Rights (1948)?
A Winston Churchill
B Eleanor Roosevelt
C Nelson Mandela
D Woodrow Wilson
Some traditional board drafters preferred the drafting machine over the parallel straight edge because it could be used without the need for _________.
A Circle templates
B Triangles
C Technical pens
D Lettering guides
Some common blocks used by architectural drafters include __________.
A Door swings
B Ceiling fans
C Appliances
D All of the above
If it takes 50 workers 4 hours to dig a hole, how long should it take 30 workers to dig the same hole?
A 2 hrs, 24 mins
B 6 hrs, 12 mins
C 5 hrs, 12 mins
D 6 hrs, 40 mins
If it takes 4 hours to dig a hole by 50 workers, how long should it take to dig the same hole by 30 workers?
A 2 hours 24 minutes
B 6 houres 12 minutes
C 5 houres 12 minutes
D 6 hours 40 minutes
In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)
A 1 d
B 1.5 d
C 2.5 d
D 2 d

Next steps