Related Questions

A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
A Architectural
B Civil
C Mechanical
D Process piping
Drafters should use a ________ in a section view of a mechanical part that includes the cylindrical view of a threaded hole.
A Center line
B Hatch line
C Poly line
D Dimension line
In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.
A Leave the view as is
B Eliminate the view
C Use the left view instead
D None of the above
When setting up a mechanical drawing in Auto-CAD the drafter should set the units to ________.
A Fractional
B Decimal
C Architectural
D Metric
When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
A Half
B Quarter
C Full
D Broken out
When using the descriptive geometry method to create an auxiliary view the drafter should _________.
A Rotate the snap grid to the same angle of the inclined plane
B Offset the right vertical line of the front view
C Rotate the top line of the front view 45 degrees
D Offset the top line of the front view 2 inches
When filling an area with a hatch pattern in Auto-CAD the drafter needs to be able to ________.
A See the entire bounding area to hatch
B Set Ortho on
C Turn ISO grid off
D Set the layer to Defpoints
In developing a multi-view drawing, the drafter can use a ________ line to help locate the top and right side views.
A Object
B Hidden
C Dimension
D Miter
When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.
A Pull the line from away from the starting point very carefully
B Insure that Ortho is on
C Enter 3 for the length of the line
D Read the coordinate position on the Dynamic Readout
A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
A Offset
B Half
C Whole
D Broken out

Next steps