Related Questions

The water in a fish tank measuring 114 feet by 8 inches is 7 inches high. The water is poured into another tank measuring 14 inches by 20 inches. What will be the height of water, in inches, in the second tank?
A 1/4
B 2
C 3
D 1/12
A rectangular box ix 10 inches wide, 10 inches long and 5 inches high . What is the greatest possible (straight line) distance , in inches, between any two points on the box ?
A 15
B 20
C 25
D 10
A rectangular box is 10 inches wide, 10 inches long, and 5 inches high. What is the greatest possible (straight line) distance, in inches, between any two points on the box?
A 15
B 20
C 25
D 10
Sobuj bought three pieces of material. The first piece is 1 yard 2 feet 6 inches long, the second piece is 2 yards 1 feet 5 inches long, and the third piece is 4 yards 2 feet 7 inches long. If the cost of the material is Tk. 36 per yard, how much did Sobuj spent?
A Tk. 324
B Tk. 342
C Tk. 350
D Tk. 330
A rectangular box is 10 inches wide, 10 inches long and 5 inches high. what is the greatest possible distance, in inches ,between any two points on the box?
A 15
B 20
C 25
D 10
A bar of soap has a volume of 18 cubic inches. Jasim used it until it measured 2.75 inches by 2 inches by 1 inch. How many cubic inches of soap did jasim use?
A 14.25
B 5.75
C 8.5
D 12.5
A border of uniform width is placed around a rectangular photograph that measures 8 inches by 10 inches. If the area of the border is 144 square inches, what is the width of the border, in inches?
A 10
B 3
C 7
D 8
A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
A Architectural
B Civil
C Mechanical
D Process piping
A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
A Remain horizontal
B Slant up towards direction of pull
C Slant down towards direction of pull
D None of the above
In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
A Detail
B Title block
C Parts list
D Isometric

Next steps