Related Questions

The bounding box method for setting up an isometric drawing helps the drafter ________.
A Confine the isometric drawing to its maximum size
B Figure what lines are to be illustrated vertical and horizontal
C Position the isometric drawing in paper space
D None of the above
Inserting blocks into a drawing file usually requires exacting placement. The drafter should insure that ________ is turned on.
A O Snaps
B Ortho
C Grid
D Dynamic Input
A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
A Architectural
B Civil
C Mechanical
D Process piping
Before starting an isometric drawing in Auto-CAD the drafter needs to ________.
A Set the grid to isometric
B Set the current layer to Def-points
C Turn Object Snap off
D Turn Ortho off
In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
A Detail
B Title block
C Parts list
D Isometric
Lines of an isometric drawing that are not parallel to the isometric axes are called this:
A Trimetric lines
B Non-isometric lines
C Multiview lines
D Dimetric lines
When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.
A Pull the line from away from the starting point very carefully
B Insure that Ortho is on
C Enter 3 for the length of the line
D Read the coordinate position on the Dynamic Readout
In order to create one solid model from two or more separate solid shapes the drafter will need to position them and then ________.
A Use Union to join them
B Use the Join command
C Use the Add Parts tool
D None of the above
To insure that everyone understands what the electrical symbols represent it is customary to include a ________ on the electrical sheet.
A List
B Part number
C Electrical legend
D Electrical layer
When using the descriptive geometry method to create an auxiliary view the drafter should _________.
A Rotate the snap grid to the same angle of the inclined plane
B Offset the right vertical line of the front view
C Rotate the top line of the front view 45 degrees
D Offset the top line of the front view 2 inches

Next steps