CCNA MCQ
Test your knowledge with important CCNA MCQ and their applications. These MCQs are beneficial for competitive exams too. Explore 30+ more CCNA MCQs on Bissoy. Bissoy App
-
Which of the following describes the creation of private networks across the Internet, enabling privacy and tunneling of non-TCP/IP protocols?
-
Which of the following uses ATM as the Data Link layer protocol that's terminated at what's known as the DSLAM?
-
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
-
When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?
-
Which of the following is true when describing a multicast address?
-
What multicast addresses does RIPng use?
-
Which command would you use to apply an access list to a router interface?
-
What router command allows you to determine whether an IP access list is enabled on a particular interface?
-
Which of the following is an example of a standard IP access list?
-
Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames?
-
You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?
-
You want to improve network performance by increasing the bandwidth available to hosts and limit the size of the broadcast domains. Which of the following options will achieve this goal?
-
Which switching technology reduces the size of a broadcast domain?
-
You have two switches connected together with two crossover cables for redundancy, and STP is disabled. Which of the following will happen between the switches?
-
If you want to disable STP on a port connected to a server, which command would you use?
-
Your switch has a port status LED that is alternating between green and amber. What could this indicate?
-
What is the purpose of Spanning Tree Protocol in a switched LAN?
-
Where are EIGRP successor routes stored?
-
You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information?
-
With which network type will OSPF establish router adjacencies but not perform the DR/BDR election process?
-
What is the administrative distance of OSPF?
-
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
-
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?
-
If you want to have more than one Telnet session open at the same time, what keystroke combination would you use?
-
You need to gather the IP address of a remote switch that is located in Hawaii. What can you do to find the address?
-
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
-
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
-
You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?
-
Which of the following commands sets the secret password to Cisco?
-
Which of the following commands will configure all the default VTY ports on a router?