The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?

A RAM should be erased and the router restarted
B Flash should be erased and the router restarted
C NVRAM should be erased and the router restarted
D The new configuration should be entered and saved

Correct Answer: NVRAM should be erased and the router restarted

Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.

Bissoy MCQ
#CCNA #CISCO Certification

Related Questions

You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
A You didn
B NVRAM is corrupted.
C The configuration register setting is incorrect.
D The newly upgraded IOS is not compatible with the hardware of the router.
A's office is 4 km due east of B's office . C's office is 6 km due north of B's office and 4 km due east of D's office. What is the straight-line distance, in km, from A's office to D's?
A 4
B 5
C 8
D 10
You have been contracted to install a windows NT network in an office that is located in a strip mall. The office is located next to the power plant of the building, so a UPS (uninterruptible power supply) has already been installed. What type of cable should you use for the network cabling? Choose the best answer.
A TI
B UTP
C Fiber-optic
D PSTN
E STP
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A Router (config-if) #encapsulation frame-relay q933a
B Router (config - if) #encapsulation frame-relay ansi
C Router (config - if) #encapsulation frame-relay ietf
D Router (config - if) #encapsulation frame-relay cisco
Which type of cable is used to connect the COM port of a host to the COM port of a router or switch?
A Crossover
B Straight-through
C Rolled
D none of these
Which type of cable is used to connect COM port of a host to the COM port a router or switch
A Crossover
B Straight -though
C Rolled
D Sheleded twisted pair
Rehana leaves her home early in the morning so that she can reach her office on time. If she walks at the rate of 7 km/hr, then she reaches her office 8 minutes late. But, if she walks at a speed of 8 km/hr, then she reaches her office 4 minutes early. What is the distance in km between Rehana's house and her office?
A 10.5
B 11.2
C 11.5
D 12.2
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
A Router>ping
B Router>trace
C Router>show ip route
D Router>show interface
You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?
A You copied the wrong configuraion into RAM
B You copied the configuration into flash memory instead
C The copy did not override the shutdown command in running-config
D The IOS became corrupted after the copy command was initiated
Suppose that you have a customer who has a central HQ and six branch offices. They anticipate adding six more branches in the near future. They wish to implement a WAN technology that will allow the branches to economically connect to HQ and you have no free ports on the HQ router. Which of the following would you recommend?
A PPP
B HDLC
C Frame Relay
D ISDN

Next steps