You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?

A You copied the wrong configuraion into RAM
B You copied the configuration into flash memory instead
C The copy did not override the shutdown command in running-config
D The IOS became corrupted after the copy command was initiated

Correct Answer: The copy did not override the shutdown command in running-config

Since the configuration looks correct, you probably didn't screw up the copy job. However , when you perform a copy from a network host to a router , the interfaces are automatically shut dow and need to be manually enabled with the no shutdown command.

Related Questions

You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
You are adding a new server to your network. The network uses TCP/IP. The new server will provide users with dial-up access to network resources. The data link communications protocol you choose for dial-up access must allow you to provide secure authentication. Which protocol should you choose?
Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?

Next steps