Bissoy.com
Doctors Medicines MCQs Q&A

Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames?

Which command will configure a switch port to use the IEEE standard method of inserting VLAN membership information into Ethernet frames? Correct Answer Switch (config-if) #switchport trunk encapsulation dot1q

If you are on a 2950 switch, then the interface command is just swichport mode trunk since the 2050 can only run the  IEEE 802.1q version. However, a 3550 can run both ISL and 802.1q, so you must also use the encapsulation command. The argument to choose 802.1q for a trunking protocol is dot1q.

Related Questions

Fact 1: Eyeglass frames cost between $35 and $350.
Fact 2: Some eyeglass frames are made of titanium.
Fact 3: Some eyeglass frames are made of plastic.

If the first three statements are facts, which of the following statements must also be a fact?
I: Titanium eyeglass frames cost more than plastic frames.
II: Expensive eyeglass frames last longer than cheap frames.
III: Only a few eyeglass frames cost less than $35.
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful?
1. TFTP server software must be running on the router.
2. TFTP server software must be running on your laptop.
3. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable.
4. The laptop must be on the same subnet as the router's Ethernet interface.
5. The copy flash tftp command must be supplied the IP address of the laptop.
To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.
2. The VTP management domain name of both switches must be set the same.
3. All ports on both the switches must be set as access ports.
4. One of the two switches must be configured as a VTP server.
5. A rollover cable is required to connect the two switches together.
6. A router must be used to forward VTP traffic between VLANs.
Which of the following protocols are used to configure trunking on a switch?
1. VLAN Trunk Protocol
2. VLAN
3. 802.1Q
4. ISL
What protocols are used to configure trunking on a switch?
1. VLAN Trunking Protocol
2. VLAN
3. 802.1Q
4. ISL
Which three statements are true about the operation of a full-duplex Ethernet network?
1. There are no collisions in full-duplex mode.
2. A dedicated switch port is required for each full-duplex node.
3. Ethernet hub ports are preconfigured for full-duplex mode.
4. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.
5. The host network card and the switch port must be capable of operating in full-duplex mode.
You are the administrator of eight SQL Server 2000 computers. You configure alerts on each server so that various problem conditions will be reported if they occur.You create 20 operators on one of the servers. You configure these operators by using the e-mail and pager contact information for the employees in your department. You configure the alerts on the server to send e-mail messages and pager messages to the appropriate operators.You need to configure the same 20 operators on the other seven servers. You want to do this with a minimum amount of administrative time.What should you do?
Consider the relation Emp-Dept with SSn as key Ename SSn EAddr Dept. No Dept. Name Dept. Manager SSn   Which of the following is (are) invalid operation(s)? a) Inserting an employee without name and address b) Inserting an employee with only SSn c) Inserting a department with no employee d) Inserting an employee without SSn
A company recruits candidates satisfying the following criteria -  1. Candidates who secured at least 85% in standard 10th or equivalent. 2. Candidates who secured at least 65% in standard 12th or equivalent. 3. Candidates who are not from commerce background. Who among the following candidates will the company definitely select? A. Jitesh is a science student having scored 70% in standard 12th and 80% in 10th with an excellent sports background. B. Jignesh scored 80% in standard 12th, 90% in standard 10th and secured 2nd place in his college among all commerce students. C. Jayesh scored 75% in standard 10th, 75% in standard 12th and is an arts student. D. Jinesh secured 80% in standard 12th, 88% in standard 10th and is a science student with great acting skills