With which network type will OSPF establish router adjacencies but not perform the DR/BDR election process?

A Point-to-Point
B Backbone area 0
C Broadcast multi-access
D Non-broadcast multi-access

Correct Answer: Point-to-Point

No DR is assigned on any type of point-to-point link. No DR/BDR is assigned on the NBMA point-to-multipoint due to the hub/spoke  topology. DR and BDR are elected on broadcast and non-broadcast multi-access network. Frame relay is a non-broadcast multiaccess (NBMA) network by default.

Bissoy MCQ
#CCNA #CISCO Certification

Related Questions

If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
A The Lowest IP address of any physical interface
B The Highest IP address of any physical interface
C The Lowest IP address of any logical interface
D The Highest IP address of any logical interface
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
A RAM should be erased and the router restarted
B Flash should be erased and the router restarted
C NVRAM should be erased and the router restarted
D The new configuration should be entered and saved
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A Router (config-if) #encapsulation frame-relay q933a
B Router (config - if) #encapsulation frame-relay ansi
C Router (config - if) #encapsulation frame-relay ietf
D Router (config - if) #encapsulation frame-relay cisco
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
A You didn
B NVRAM is corrupted.
C The configuration register setting is incorrect.
D The newly upgraded IOS is not compatible with the hardware of the router.
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
A show running-config
B show startup-config
C show interfaces
D show protocols
.........is a network topology in which each network component is physically connected to a central node such as a router, hub or switch.
A Bus topology
B Ring topology
C Mesh topology
D Star topology
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
A Router>ping
B Router>trace
C Router>show ip route
D Router>show interface
All performers want to perform well. Perform who want to perform well exercise regular Therefore, performers who do not exercise are performers. In light of the above argument which of the following statements is true?
A All performers exercise.
B Performers should exercise frequently
C Exercise is inevitable
D Without exercise no performer can perform well.
You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?
A You copied the wrong configuraion into RAM
B You copied the configuration into flash memory instead
C The copy did not override the shutdown command in running-config
D The IOS became corrupted after the copy command was initiated
A network administrator needs to configure a router with a distance-vector protocol that allows classless routing. Which of the following satisfies those requirements?
A IGRP
B OSPF
C RIPv1
D EIGRP
E IS-IS

Next steps