You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?

A You must type the show ip rip command first
B IP addressing on the network is incorrect
C You must use the terminal monitor command
D Debug output is sent only to the console.

Correct Answer: You must use the terminal monitor command

To see console messages through your Telnet session, you must enter the terminal monitor command.

Bissoy MCQ
#CCNA #CISCO Certification

Related Questions

You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?
A close
B disable
C disconnect
D exit
What command is used to stop RIP routing updates from exiting out an interface but still allow the interface to receive RIP route updates?
A Router (config-if) # no routing
B Router (config-if) # passive-interface
C Router (config-router) # passive-interface s0
D Router (config-router) # no routing updates
Which command displays RIP routing updates?
A Show IP route
B Debug IP rip
C Show protocols
D Debug IP route
If you want to have more than one Telnet session open at the same time, what keystroke combination would you use?
A Tab+spacebar
B Ctrl+X, then 6
C Ctrl+Shift+X, then 6
D Ctrl+Shift+6, then X
If you use either Telnet or FTP, which is the highest layer you are using to transmit data?
A Application
B Presentation
C Session
D Transport
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
A Router>ping
B Router>trace
C Router>show ip route
D Router>show interface
Which of the following commands will allow you to set your Telnet password on a Cisco router?
A line telnet 0 4
B line aux 0 4
C line vty 0 4
D line con 0
Which of the following represents examples of an IT input device, output device and storage device respectively ?
A bar code reader, CD drive, projector
B keyboard, monitor, hard disc
C printer, DVD drive, joystick
D printer, mouse, monitor
You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?
A The router is not configured for the new host
B The VTP configuration on the switch is not updated for the new host
C The host has an invalid MAC address
D The switch port the host is connected to is not configured with the correct VLAN membership
How many simultaneous Telnet sessions does a Cisco router support by default?
A 2
B 3
C 4
D 5

Next steps