Bissoy.com
Doctors Medicines MCQs Q&A

Consider the amplifier circuit shown below. The transistor is specified to have Vt = 0.4 V, kn = 0.4 mA/V2, W/L = 10 and λ = 0. Also, let VDD = 1.8V, RD = 17.5kΩ, VGS = 0.6V and vgs = 0V. Find VDS.

Consider the amplifier circuit shown below. The transistor is specified to have Vt = 0.4 V, kn = 0.4 mA/V2, W/L = 10 and λ = 0. Also, let VDD = 1.8V, RD = 17.5kΩ, VGS = 0.6V and vgs = 0V. Find VDS. Correct Answer 0.4 V

n:

Related Questions

Consider the amplifier circuit shown below. The transistor is specified to have Vt = 0.4 V, kn = 0.4 mA/V2, W/L = 10 and λ = 0. Also, let VDD = 1.8V, RD = 17.5kΩ, VGS = 0.6V and vgs = 0V. Find ID.
We know ID =1/2 kn (VGS + vgs – Vt)2. Let the signal vgs be a sine wave with amplitude Vgs, and substitute vgs = Vgs sin ω t in Eq.(5.43). Using the trigonometric identity show that the ratio of the signal at frequency 2ω to that at frequency ω , expressed as a percentage (known as the second-harmonic distortion) is
For a p-channel FET, the current ID at Vgs = 2V and Vds = 5V and Vgs = 3V was found to be 2mA, what will be the value of ID at Vgs = 0V and Vds = 5V?
For an n-channel FET, the current v at Vgs=-2V and Vds=5V was found to be 2mA, what will be the value of ID at Vgs=0V and Vds=5V?
Consider the following statements regarding n-channel JFET: 1. The maximum drain current IDSS occurs when gate-to-source voltage VGS = 0 V and drain-to-source voltage VDS ≥ |VP|. (VP is pinch-off voltage). 2. For gate-to-source voltage VGS less than the pinch-off level, the drain current is 0 A. 3. For all levels of VGS between 0 V and the pinch-off level, the current ID will range between IDSS and 0 A, respectively. which of the above statements are correct ?
Consider the circuit shown. VDS=3 V. If IDS=2mA, find VDD to bias circuit.
Consider the amplifier below for the case VDD = 5 V, RD = 24 kΩ, (W/L) = 1 mA/V2, and Vt = 1 V. For amplifier biased to operate with an overdrive voltage of 0.5V, and disregarding the distortion caused by the MOSFET’s square-law characteristic, what is the largest amplitude of a sine-wave voltage signal that can be applied at the input while the transistor remains in saturation?
The following statements refer to an n channel FET operated in the active region: 1. The gate voltage VGS reverse biases the junction 2. The drain voltage VDD is negative with respect to the source 3. The current in the n channel is due to electrons 4. Increasing the reveres bias VGS increases the cross section for conduction Which of these statements are correct?
Consider an NMOS transistor having kn= 2 mA/V2. Let the transistor be biased at VOV = 1V. For operation in saturation, what dc bias current ID results? If a +0.1-V signal is superimposed on VGS, find the corresponding increment in collector current by evaluating the total collector current ID and subtracting the dc bias current ID.
Consider the amplifier below for the case VDD = 5 V, RD = 24 kΩ, (W/L) = 1 mA/V2, and Vt = 1 V. If the amplifier is biased to operate with an overdrive voltage VOV of 0.5 V, find the incremental gain at the bias point.