Bissoy.com
Doctors Medicines MCQs Q&A

Consider an NMOS transistor having kn= 2 mA/V2. Let the transistor be biased at VOV = 1V. For operation in saturation, what dc bias current ID results? If a +0.1-V signal is superimposed on VGS, find the corresponding increment in collector current by evaluating the total collector current ID and subtracting the dc bias current ID.

Consider an NMOS transistor having kn= 2 mA/V2. Let the transistor be biased at VOV = 1V. For operation in saturation, what dc bias current ID results? If a +0.1-V signal is superimposed on VGS, find the corresponding increment in collector current by evaluating the total collector current ID and subtracting the dc bias current ID. Correct Answer ID = 1mA and Increment = 0.21 mA

n:

Related Questions

We know ID =1/2 kn (VGS + vgs – Vt)2. Let the signal vgs be a sine wave with amplitude Vgs, and substitute vgs = Vgs sin ω t in Eq.(5.43). Using the trigonometric identity show that the ratio of the signal at frequency 2ω to that at frequency ω , expressed as a percentage (known as the second-harmonic distortion) is
An NMOS transistor is operating at the edge of saturation with an overdrive voltage VOV and a drain current ID. If is VOV is doubled, and we must maintain operation at the edge of saturation, what value of drain current results?
For transistor action (a) Base, emitter, and collector regions should have similar size and doping concentrations. (b) The base region must be very thin and lightly doped. (c) The emitter-base junction is forward biased and the base-collector junction is reverse biased. (d) Both the emitter-base junction as well as the base-collector junction are forward biased. Which one of the following pairs of statements is correct?
Which of the following conditions must be satisfied for a transistor to be in saturation? 1. Its collector to base junction should be under forward bias 2. Its collector to base junction should be under reverse bias 3. Its emitter to base junction should be under reverse bias 4. Its emitter to base junction should be under forward bias Which of the above conditions are correct?
Consider the following statements regarding n-channel JFET: 1. The maximum drain current IDSS occurs when gate-to-source voltage VGS = 0 V and drain-to-source voltage VDS ≥ |VP|. (VP is pinch-off voltage). 2. For gate-to-source voltage VGS less than the pinch-off level, the drain current is 0 A. 3. For all levels of VGS between 0 V and the pinch-off level, the current ID will range between IDSS and 0 A, respectively. which of the above statements are correct ?
A transistor is used in common emitter mode as an amplifier. Then a. The base-emitter junction is forward biased b. The base-emitter junction is reverse biased  c. The input signal is connected in series with the voltage applied to the base-emitter junction  d. The input signal is connected in series with the voltage applied to bias the base-collector junction Which of the following statement is true?
Determine the conditions in which the MOSFET is operating in the saturation region. i. VGD > Vt (Threshold voltage) ii. VDS > VOV iii. ID ∝ (VOV)2
Consider the amplifier circuit shown below. The transistor is specified to have Vt = 0.4 V, kn = 0.4 mA/V2, W/L = 10 and λ = 0. Also, let VDD = 1.8V, RD = 17.5kΩ, VGS = 0.6V and vgs = 0V. Find ID.
Consider the amplifier circuit shown below. The transistor is specified to have Vt = 0.4 V, kn = 0.4 mA/V2, W/L = 10 and λ = 0. Also, let VDD = 1.8V, RD = 17.5kΩ, VGS = 0.6V and vgs = 0V. Find VDS.
Consider the following statements regarding an N-P-N Bipolar Junction Transistor: 1. Emitter diode is forward biased and the collector diode is reverse biased 2. Emitter has many free electrons 3. Free electrons are injected into the base and pass through the collector 4. Depletion layers around junction J1 and J2 of BJT are widened. Which of the above statements are correct?