Bissoy.com
Doctors Medicines MCQs Q&A

For a p-channel FET, the current ID at Vgs = 2V and Vds = 5V and Vgs = 3V was found to be 2mA, what will be the value of ID at Vgs = 0V and Vds = 5V?

For a p-channel FET, the current ID at Vgs = 2V and Vds = 5V and Vgs = 3V was found to be 2mA, what will be the value of ID at Vgs = 0V and Vds = 5V? Correct Answer 0A

We know that for a p channel FET, the current will flow only if Vgs is lesser than Vgs, but here pinch off voltage is 3V, when Vgs=5V which is greater than pinch off voltage the channel will be destroyed resulting in no conventional current flow.

Related Questions

For an n-channel FET, the current v at Vgs=-2V and Vds=5V was found to be 2mA, what will be the value of ID at Vgs=0V and Vds=5V?
We know ID =1/2 kn (VGS + vgs – Vt)2. Let the signal vgs be a sine wave with amplitude Vgs, and substitute vgs = Vgs sin ω t in Eq.(5.43). Using the trigonometric identity show that the ratio of the signal at frequency 2ω to that at frequency ω , expressed as a percentage (known as the second-harmonic distortion) is
Consider the following statements regarding n-channel JFET: 1. The maximum drain current IDSS occurs when gate-to-source voltage VGS = 0 V and drain-to-source voltage VDS ≥ |VP|. (VP is pinch-off voltage). 2. For gate-to-source voltage VGS less than the pinch-off level, the drain current is 0 A. 3. For all levels of VGS between 0 V and the pinch-off level, the current ID will range between IDSS and 0 A, respectively. which of the above statements are correct ?
For a FET having IDSS=2mA Vgs=2V and Vp=-1V, What is the value of source current?
The following statements refer to an n channel FET operated in the active region: 1. The gate voltage VGS reverse biases the junction 2. The drain voltage VDD is negative with respect to the source 3. The current in the n channel is due to electrons 4. Increasing the reveres bias VGS increases the cross section for conduction Which of these statements are correct?
Consider the amplifier circuit shown below. The transistor is specified to have Vt = 0.4 V, kn = 0.4 mA/V2, W/L = 10 and λ = 0. Also, let VDD = 1.8V, RD = 17.5kΩ, VGS = 0.6V and vgs = 0V. Find VDS.
For a FET, graph is drawn by taking voltage VGS in X axis and drain current in Y axis, if the value of X changes from 10 to 20 results in change in value of Y axis from 2 to 3. What is the value of trans conductance?
Find the current through gate if the FET was given with gate to source voltage =10V and drain to source voltage =20V, the pinch off voltage was -2V and ID=2mA.
Consider the circuit shown. VDS=3 V. If IDS=2mA, find VDD to bias circuit.
Which of the following statement/s about MOSFET is correct? (I) In the P-type device current flows due to electrons. (II) In depletion type of MOSFET channel is already present. (III) Pinch-off occurs at VDS < VGS − VTH