If I glue the plexiglass to the wood strip first, will that keep it from breaking when I drill it?

You usually only need one or the other. Really it's whatever you like. I personally like primer better, but it is up to you. Try both and see which one...

You'll have to either staple or glue the carpet down or use Tackless Strips to affix the carpet properly. You'll want to roll or fold the edge so a vacuum...

You can use a Dremel tool to drill a hole in wood. It gives you an option to use a variety of bits to drill holes of different sizes.

Use a dry dust microfiber cloth to dust the surface very softly—this specialty cloth attracts dust like a magnet. Then, fold your glass microfiber cloth into 4, spray your glass...

Purchase a vice drill, which is a pencil-shaped vice with small drill bits. They are available in craft stores. You may need to purchase smaller drill bits if the hole...

There are special drill bits. They aren't "needed," but they are helpful and do a better job.

Yes, but it's not really worth it since you will be adding shaving cream. The lotion, shaving cream, and foaming hand wash will make the glue look white, instead of...

You can use clear glue, or any type of liquid craft glue. If you use a glue stick you will have to microwave it.

Use an electric drill with a masonry bit. Start slowly and increase speed and pressure as needed. Be patient.

Use an abrasive diamond drill bit, and work with your drill set to the lowest speed. Go slowly, and frequently dip the drill bit in a little bit of water...