1 Answers
Talk Doctor Online in Bissoy App
I replaced a 16V transformer for a doorbell, that was mounted on my electric panel box. The old transformer had no ground wire, but the new one does. Can I drill a hole in the box to attach the ground?
No, you would generally need to run the equipment grounding conductor (EGC) in the same cable as the line and neutral conductors that supply the transformer in its new location,...
2 Answers 1 views
After using transfer paper onto wood is there a way to remove the markings from the wood? I messed up and need to remove what I traced?
You could use nail polish remover. Just dab it in a cloth and rub it gently on the surface to remove the markings.
2 Answers 1 views
I have some nicely dried wood from a pear tree I cut down last year. Will this make a good smoking wood?
Yes, if you allow it to dry all the way. Moist wood is to hard to use, but dry wood can be used.
2 Answers 1 views
What type of wood works best for making custom wood signs?
For outdoor use, I recommend using Douglas fir or vertical grain Douglas fir. These woods hold up very well in outdoor conditions over time. For indoor signs, good choices are...
2 Answers 1 views
What type of wood is used for the frame? Is it 2 inch square wood?
When people say 2 by 4, the wood is actually 1 and a half inches by 3 and a half inches. When you go to purchase the wood you can...
2 Answers 1 views
How do I drill a hole in a plastic bead? The beads I have already have a hole, but I need another hole perpendicular to the first.
Purchase a vice drill, which is a pencil-shaped vice with small drill bits. They are available in craft stores. You may need to purchase smaller drill bits if the hole...
2 Answers 1 views
If I glue the plexiglass to the wood strip first, will that keep it from breaking when I drill it?
The trick is to go slowly, use a good sharp bit, and ensure that the section of material you are drilling is supported and will not bend, twist, or otherwise...
2 Answers 1 views
Should I be concerned about wood splitting at a later date when using soft wood?
Not overly.
2 Answers 1 views
How do you lighten a wood stain without sanding the wood?
Use a furniture refinisher to dissolve the stain and scrub it away with a bit of steel wool. Although it still involves some scrubbing, this approach is less damaging to...
2 Answers 1 views
How do I cut a larger arm hole without creating a gap in the fabric of the hole where the breast is?
Cut downwards and not forwards. If you cut forwards, it will leave a gap and expose the breast area.
2 Answers 1 views