How do I cut a larger arm hole without creating a gap in the fabric of the hole where the breast is?
1 Answers
Talk Doctor Online in Bissoy App
When setting the 2x6 to the post do I need to leave a gap between the boards to allow for expanding, and if so, what size gap is best? Or can they be stacked on top of each other?
I'd recommend putting a 16 penny nail or a deck screw between the boards to space them for expansion. If you are worried about dirt coming through that space, you...
1 Answers 1 views
How do you clean fabric vertical blinds without taking them down?
Use a mild detergent or soap with a microfiber rag to blot up any messes on your fabric vertical blinds. Just make sure to hold and support the blinds as...
1 Answers 1 views
How do I drill a hole in a plastic bead? The beads I have already have a hole, but I need another hole perpendicular to the first.
Purchase a vice drill, which is a pencil-shaped vice with small drill bits. They are available in craft stores. You may need to purchase smaller drill bits if the hole...
1 Answers 1 views
What if my arm can't reach that high or my leg is just too long for my arm?
If you can't reach, try holding your ankle or lower thigh instead of holding your foot.
1 Answers 1 views
How do you cut the fabric for a tie?
It's important to cut the fabric on a bias, which will make it more flexible. Then, it's best to hand-stitch the tie, because machine stitches aren't very flexible, and the...
1 Answers 1 views
I have a 5 x 3 and 3 ft hole I need to fill in my garage. Do I fill the hole with bricks as well?
Since you likely need to dig down to level the the ground and to make room for your gravel base, you can fill it with the soil. And if the...
1 Answers 1 views
I found a tree growing out of nectarine seed in my yard (I think a squirrel planted it). It has grown to about 18" tall with 3 main stems. Should I cut 2 stems off, or let it grow larger first?
ভাতিজা (ভাইয়ের ছেলে), ভাগিনা ( বোনের ছেলে)।
1 Answers 1 views
How do I cut the steel rod in the tie rod hole?
To cut a steel tie, you will need a diamond-blade grinder and safety glasses.
1 Answers 1 views
I cut the fabric 18" long and the elastic 7" long. The finished product was really tight. My question is, how wide is the hole on the scrunchie?
The opening scrunchie holes that you thread elastic through should be about 1 and 1/2 inches.
1 Answers 1 views