Purchase a vice drill, which is a pencil-shaped vice with small drill bits. They are available in craft stores. You may need to purchase smaller drill bits if the hole...
2 Answers 1 viewsIt should show cut-in pressure just below the typical 30 psi mark. That way, when a user opens a valve and the pressure in the system and tank drops below...
2 Answers 1 viewsI think so. I prefer using a wooden dowel, but steel should resist rain and impacts better. You probably can't throw it as far, but it should still work.
2 Answers 1 viewsCut downwards and not forwards. If you cut forwards, it will leave a gap and expose the breast area.
2 Answers 1 viewsIt's important to cut the fabric on a bias, which will make it more flexible. Then, it's best to hand-stitch the tie, because machine stitches aren't very flexible, and the...
2 Answers 1 viewsSince you likely need to dig down to level the the ground and to make room for your gravel base, you can fill it with the soil. And if the...
2 Answers 1 viewsYes, it is designed to activate slowly with water, so you can insert and tighten as water is entering the hole.
2 Answers 1 viewsThe opening scrunchie holes that you thread elastic through should be about 1 and 1/2 inches.
2 Answers 1 viewsTie it in a knot at your navel and then tie the straps around your waist, as that will give you more of a deep V-fit. That's probably a very...
2 Answers 1 views