Is there a special bit needed to drill plexiglass?

If a computer has a 64-bit processor, it is backwards compatible with 32-bit software, and you can run 32-bit Windows as well, though the manufacturer may not have 32-bit versions...

When you jump from the board with your takeoff leg, drive your opposite leg up into the air. Once your takeoff foot leaves the board, your opposite knee should drive...

Normally what I do is tilt my head downward so that there's a shadow over my eyes, and either smile or make wide eyes (not too wide, just wide enough...

Use a dry dust microfiber cloth to dust the surface very softly—this specialty cloth attracts dust like a magnet. Then, fold your glass microfiber cloth into 4, spray your glass...

Cut plexiglass to shape (ie: for the backing on shaped puzzles) by using a Dremel tool with grinder blades. It literally melts the plastic instead of cutting it and prevents...

You can turn the front of almost all drills these days to easily loosen it up.

The trick is to go slowly, use a good sharp bit, and ensure that the section of material you are drilling is supported and will not bend, twist, or otherwise...

One tip is to use the torque settings. When you use a power drill, you can either use it so that it just keeps moving or you can use the...

Most are plug-and-play if you have an fairly new (i.e. Windows 7 or higher) PC. If the NIC you are using is ancient, you will need to find drivers; otherwise,...

Grab a pair of channel locks and tighten them up around the drill bit. Then, unscrew the drill bit manually with the channel locks.