- addroute
- route
- netstat
- net
- None of the above
1 Answers
Call
Talk Doctor Online in Bissoy App
If you wanted administrators to see a message when logging into the router, which command would you use?
Answer: Option 3 The typical banner is a message of the day (MOTD) and is set by using the global configuration mode command banner motd.
1 Answers 1 views
A motorist knows four different routes from Bristol to Birmingham. From Birmingham to Sheffield he knows three different routes and from Sheffield to Carlisle he knows two different routes. How many routes does he know from Bristol to Carlisle ?
Answer: Option 4 Total number of routes from Bristol to Carlisle = (4 x 3 x 2) = 24.
1 Answers 1 views
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
Answer: Option 3 If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the...
1 Answers 1 views
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
Answer: Option 3 The command show ip protocols will actually show you the broadcast address for each interface - too bad it isn't a possible answer. Your best answer is...
1 Answers 1 views
You want to totally reinitialize the router and replace the current running-config with the current startup-config. What command will you use?
Answer: Option 4 To completely replace the running-config with the startup-config, you must reload the router. Note : You may have picked option C, which isn't a bad answer. Remember,...
1 Answers 1 views
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
Answer: Option 2 The command traceroute (trace for short), which can be issued from user mode or privileged mode, is used to find the path a packet takes through an...
1 Answers 3 views
You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?
Answer: Option 4 Since the question never mentioned anything about a suspended session, you can assume that the Telnet session is still open, and you would just type exit to...
1 Answers 1 views
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
Answer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.
1 Answers 1 views
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
Answer: Option 3 If you have a Cisco router on one side of a Frame Relay network and a non-Cisco router on the other side, you would need to use...
1 Answers 1 views
Which command will display all the EIGRP feasible successor routes known to a router?
Answer: Option 3 Any secondary route to a remote network is considered a feasible successor, and those routes are only found in the topology table and used as backup routes...
1 Answers 1 views