- show running-config
- show startup-config
- show interfaces
- show protocols
1 Answers
Call
Talk Doctor Online in Bissoy App
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
Answer: Option 3 If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the...
1 Answers 1 views
You are the administrator responsible for security and user desktop settings on your network. You need to configure a custom registry entry for all users. You want to add the custom registry entry into a Group Policy object (GPO) with the least amount of administrative effort What should you do?
Answer: Option 1 Let'
1 Answers 6 views
Computer accounts and user accounts in your domain have been seperated into OUs for administrative purpose. You want to require strong passwords for the local user accounts only. What should you do?
Answer: Option 1 Let'
1 Answers 2 views
Your company has a LAN in its downtown office and has now set up a LAN in the manufacturing plant in the suburbs. To enable everyone to share data and resources between the two LANs, what type of device(s) are needed to connect them Choose the most correct answer.?
Answer: Option 4 Let'
1 Answers 1 views
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
Answer: Option 2 The command traceroute (trace for short), which can be issued from user mode or privileged mode, is used to find the path a packet takes through an...
1 Answers 3 views
You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?
Answer: Option 4 Since the question never mentioned anything about a suspended session, you can assume that the Telnet session is still open, and you would just type exit to...
1 Answers 1 views
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
Answer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.
1 Answers 1 views
You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information?
Answer: Option 4 The show ip eigrp neighbors command allows you to check the IP addresses as well as the retransmit interval and queue counts for the neighbors that have...
1 Answers 1 views
Your company uses both Ethernet and token-ring LAN's in the same building. Users need access to resources and the ability to transmit data between the LAN's. Which device would you use to enable communications between dissimilar LAN's that use different protocols?
Answer: Option 3 Let'
1 Answers 1 views
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
Answer: Option 3 If you have a Cisco router on one side of a Frame Relay network and a non-Cisco router on the other side, you would need to use...
1 Answers 1 views