- close
- disable
- disconnect
- exit
1 Answers
Call
Talk Doctor Online in Bissoy App
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
Answer: Option 3 If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the...
1 Answers 1 views
Yoga has become a very popular type of exercise, but it may not be for everyone. Before you sign yourself up for a yoga class, you need to examine what it is you want from your fitness routine. If you're looking for a high-energy, fast-paced aerobic workout, a yoga class might not be your best choice. This paragraph best supports the statement that?
Answer: Option 2 The second sentence points out that people should examine what they want from a fitness routine before signing up for a new exercise class. There is...
1 Answers 2 views
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
Answer: Option 3 The command show ip protocols will actually show you the broadcast address for each interface - too bad it isn't a possible answer. Your best answer is...
1 Answers 1 views
You want to totally reinitialize the router and replace the current running-config with the current startup-config. What command will you use?
Answer: Option 4 To completely replace the running-config with the startup-config, you must reload the router. Note : You may have picked option C, which isn't a bad answer. Remember,...
1 Answers 1 views
If you want to have more than one Telnet session open at the same time, what keystroke combination would you use?
Answer: Option 4 To keep open one or more Telnet sessions, use the Ctrl+Shift+6 and then X keystroke combination.
1 Answers 1 views
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
Answer: Option 2 The command traceroute (trace for short), which can be issued from user mode or privileged mode, is used to find the path a packet takes through an...
1 Answers 3 views
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?
Answer: Option 3 To see console messages through your Telnet session, you must enter the terminal monitor command.
1 Answers 2 views
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
Answer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.
1 Answers 1 views
Which of the following commands will allow you to set your Telnet password on a Cisco router?
Answer: Option 3 The command line vty 0 4 places you in a prompt that will allow you to set or change your Telnet password.
1 Answers 1 views
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
Answer: Option 3 If you have a Cisco router on one side of a Frame Relay network and a non-Cisco router on the other side, you would need to use...
1 Answers 1 views