- line telnet 0 4
- line aux 0 4
- line vty 0 4
- line con 0
1 Answers
Call
Talk Doctor Online in Bissoy App
How many simultaneous Telnet sessions does a Cisco router support by default?
Answer: Option 4 Cisco routers, if they do not have the Enterprise edition of the IOS, will default to 5 simultaneous Telnet sessions.
1 Answers 1 views
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
Answer: Option 3 If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the...
1 Answers 1 views
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
Answer: Option 3 The command show ip protocols will actually show you the broadcast address for each interface - too bad it isn't a possible answer. Your best answer is...
1 Answers 1 views
You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?
Answer: Option 4 Since the question never mentioned anything about a suspended session, you can assume that the Telnet session is still open, and you would just type exit to...
1 Answers 1 views
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
Answer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.
1 Answers 1 views
Which of the following commands sets the secret password to Cisco?
Answer: Option 3 The enable secret password is case sensitive, so the second option is wrong. To set the enable secret <password>, use the enable secret <password> command from global...
1 Answers 1 views
Which of the following series of commands will restrict Telnet access to the router?
Answer: Option 3 Telnet access to the router is restricted by using either a standard or extended IP access list inbound on the VTY lines of the router. The command...
1 Answers 1 views
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
Answer: Option 3 If you have a Cisco router on one side of a Frame Relay network and a non-Cisco router on the other side, you would need to use...
1 Answers 1 views
Suppose that you have a customer who has a central HQ and six branch offices. They anticipate adding six more branches in the near future. They wish to implement a WAN technology that will allow the branches to economically connect to HQ and you have no free ports on the HQ router. Which of the following would you recommend?
Answer: Option 3 The key is "there are no free ports" on your router. Only Frame Relay can provide a connection to multiple locations with one interface, and in an...
1 Answers 2 views
Which command will allow you to see real-time translations on your router?
Answer: Option 3 The command debug ip nat will show you in real time the translations occurring on your router.
1 Answers 1 views