- replace run start
- copy run start
- copy start run
- reload
1 Answers
Call
Talk Doctor Online in Bissoy App
If you wanted administrators to see a message when logging into the router, which command would you use?
Answer: Option 3 The typical banner is a message of the day (MOTD) and is set by using the global configuration mode command banner motd.
1 Answers 1 views
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
Answer: Option 3 If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the...
1 Answers 1 views
Which command will show you the IOS version running on your router?
Answer: Option 3 The best answer is show version, which shows you the IOS file running currently on your router. The show flash command shows you the contents of flash...
1 Answers 1 views
You have configured a Group Policy Object (GPO) for the marketing oranization unit (OU) to prevent users from accessing My Network Places and from running System in Control Panel. You want the Managers Domain Local Group to be able to access My Network Places, but you still want to prevent them from running System in Control Panel. What should you do?
Answer: Option 4 Let'
1 Answers 1 views
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
Answer: Option 3 The command show ip protocols will actually show you the broadcast address for each interface - too bad it isn't a possible answer. Your best answer is...
1 Answers 1 views
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
Answer: Option 2 The command traceroute (trace for short), which can be issued from user mode or privileged mode, is used to find the path a packet takes through an...
1 Answers 3 views
You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?
Answer: Option 4 Since the question never mentioned anything about a suspended session, you can assume that the Telnet session is still open, and you would just type exit to...
1 Answers 1 views
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
Answer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.
1 Answers 1 views
A network administrator wants to upgrade the IOS of a router without removing the image currently installed. What command will display the amount of memory consumed by the current IOS image and indicate whether there is enough room available to hold both the current and new images?
Answer: Option 2 The show flash command will provide you with the current IOS name and size and the size of flash memory.
1 Answers 5 views
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
Answer: Option 3 If you have a Cisco router on one side of a Frame Relay network and a non-Cisco router on the other side, you would need to use...
1 Answers 1 views