- message banner motd
- banner message motd
- banner motd
- message motd
Answer: Option 3 If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the...
1 Answers 1 viewsAnswer: Option 2 Let'
1 Answers 1 viewsAnswer: Option 3 The command show ip protocols will actually show you the broadcast address for each interface - too bad it isn't a possible answer. Your best answer is...
1 Answers 1 viewsAnswer: Option 4 To completely replace the running-config with the startup-config, you must reload the router. Note : You may have picked option C, which isn't a bad answer. Remember,...
1 Answers 1 viewsAnswer: Option 2 The command traceroute (trace for short), which can be issued from user mode or privileged mode, is used to find the path a packet takes through an...
1 Answers 3 viewsAnswer: Option 4 Since the question never mentioned anything about a suspended session, you can assume that the Telnet session is still open, and you would just type exit to...
1 Answers 1 viewsAnswer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.
1 Answers 1 viewsAnswer: Option 2 At the moment of OSPF process startup, the highest IP address on any active interface will be the Router ID (RID) of the router. If you have...
1 Answers 5 views