- You must type the show ip rip command first.
- IP addressing on the network is incorrect.
- You must use the terminal monitor command.
- Debug output is sent only to the console.
Answer: Option 2 RIP has an administrative distance (AD) of 120, while IGRP has an administrative distance of 100, so the router will discard any route with a higher AD...
1 Answers 1 viewsAnswer: Option 4 Let'
1 Answers 1 viewsAnswer: Option 3 The command show ip protocols will actually show you the broadcast address for each interface - too bad it isn't a possible answer. Your best answer is...
1 Answers 1 viewsAnswer: Option 3 The (config-router) #passive-interface command stops updates from being sent out an interface, but route updates are still received.
1 Answers 2 viewsAnswer: Option 4 To keep open one or more Telnet sessions, use the Ctrl+Shift+6 and then X keystroke combination.
1 Answers 1 viewsAnswer: Option 2 The command traceroute (trace for short), which can be issued from user mode or privileged mode, is used to find the path a packet takes through an...
1 Answers 3 viewsAnswer: Option 4 Since the question never mentioned anything about a suspended session, you can assume that the Telnet session is still open, and you would just type exit to...
1 Answers 1 viewsAnswer: Option 4 This question is a little vague, but the best answer is that the VLAN membership for the port is not configured.
1 Answers 1 viewsAnswer: Option 1 Both FTP and Telnet use TCP at the Transport layer; however, they both are Application layer protocols, so the Application layer is the best answer.
1 Answers 7 views