- Router (config-if) # no routing
- Router (config-if) # passive-interface
- Router (config-router) # passive-interface s0
- Router (config-router) # no routing updates
Answer: Option 2 When a routing update is received by a router, the router first checks the administrative distance (AD) and always chooses the route with the lowest AD. However,...
1 Answers 1 viewsAnswer: Option 2 RIP has an administrative distance (AD) of 120, while IGRP has an administrative distance of 100, so the router will discard any route with a higher AD...
1 Answers 1 viewsAnswer: Option 1 If you have a serial port configured with multiple DLCIs connected to multiple remote sites, split horizon rules, stop route updates received on an interface from being...
1 Answers 1 viewsAnswer: Option 3 The program will compile and execute successfully as you can declare methods with same name in an interface and the method of either interface can be used,...
1 Answers 1 viewsAnswer: Option 2 The passive command, short for passive-interface, stops regular updates from being sent out an interface. However, the interface can still receive updates.
1 Answers 2 viewsAnswer: Option 3 To see console messages through your Telnet session, you must enter the terminal monitor command.
1 Answers 2 viewsAnswer: Option 1 Clearly, peaceful settlement through mutual agreement is the best option, whatever be the issue. So, argument I holds strong. Moreover, the problem indicated in II can be...
1 Answers 1 viewsAnswer: Option 2 The debug ip rip command is used to show the Internet Protocol (IP) Routing Information Protocol (RIP) updates being sent and received on the router.
1 Answers 1 viewsAnswer: Option 3 Static routes have an administrative distance of 1 by default. Unless you change this, a static route will always be used over any other found route. IGRP...
1 Answers 1 viewsAnswer: Option 4 Black Sea will likely to be flown over by Mr. X.
1 Answers 1 views