- IGRP has a faster update timer.
- IGRP has a lower administrative distance.
- RIP has a higher metric value for that route.
- The IGRP route has fewer hops.
1 Answers
Call
Talk Doctor Online in Bissoy App
Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?
Answer: Option 2 When a routing update is received by a router, the router first checks the administrative distance (AD) and always chooses the route with the lowest AD. However,...
1 Answers 1 views
A station in a network forwards incoming packets by placing them on its shortest output queue. What routing algorithm is being used?
Answer: Option 1 Let'
1 Answers 1 views
What command is used to stop RIP routing updates from exiting out an interface but still allow the interface to receive RIP route updates?
Answer: Option 3 The (config-router) #passive-interface command stops updates from being sent out an interface, but route updates are still received.
1 Answers 2 views
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
Answer: Option 2 The command traceroute (trace for short), which can be issued from user mode or privileged mode, is used to find the path a packet takes through an...
1 Answers 3 views
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?
Answer: Option 3 To see console messages through your Telnet session, you must enter the terminal monitor command.
1 Answers 2 views
A network administrator wants to upgrade the IOS of a router without removing the image currently installed. What command will display the amount of memory consumed by the current IOS image and indicate whether there is enough room available to hold both the current and new images?
Answer: Option 2 The show flash command will provide you with the current IOS name and size and the size of flash memory.
1 Answers 5 views
Directions : In each of the following questions a statement is given, followed by two conclusions. Give answer : Statements : In a highly centralised power structure, in which even senior cabinet ministers are prepared to reduce themselves to pathetic countries or yesmen airing views that are primarily intended to anticipate or reflect the Prime Minister's own performances, there can be no place for any consensus that is quite different from real or contrived unanimity of opinion, expressed through a well orchestrated endorsement of the leader's actions. Conclusions : I. The Ministers play safe by not giving anti-government views. II. The Prime Minister does not encourage his colleagues to render their own views.?
Answer: Option 1 According to the statement, even senior cabinet ministers are always ready to conform to the Prime Minister's views. So, I follows. However, II contradicts the given statement...
1 Answers 5 views
Which command displays RIP routing updates?
Answer: Option 2 The debug ip rip command is used to show the Internet Protocol (IP) Routing Information Protocol (RIP) updates being sent and received on the router.
1 Answers 1 views
If your routing table has a static, a RIP, and an IGRP route to the same network, which route will be used to route packets by default?
Answer: Option 3 Static routes have an administrative distance of 1 by default. Unless you change this, a static route will always be used over any other found route. IGRP...
1 Answers 1 views
A network administrator needs to configure a router with a distance-vector protocol that allows classless routing. Which of the following satisfies those requirements?
Answer: Option 4 In this question, we're calling EIGRP just plain old distance vector. EIGRP is an "advanced" distance-vector routing protocol, sometimes called a hybrid routing protocol because it uses...
1 Answers 1 views