You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information?

show ip eigrp adjacency
show ip eigrp topology
show ip eigrp interfaces
show ip eigrp neighbors

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

The show ip eigrp neighbors command allows you to check the IP addresses as well as the retransmit interval and queue counts for the neighbors that have established an adjacency.

5 views Answered 2022-09-01 13:21

Related Questions

You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?

1 Answers 5 Views

What happens if the following program is compiled and executed interface MyInterface{ void display(); } interface MySubInterface extends MyInterface{ void display(); } public class Test implements MySubInterface{ public void display(){ System.out.print("Welcome to Examveda."); } public static void main(String args[]){ Test t = new Test(); t.display(); } }?

1 Answers 5 Views

You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?

1 Answers 4 Views

The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?

1 Answers 5 Views

If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?

1 Answers 9 Views

Which command is used to display the subdirectory structure of the currently logged drive and pause the screen display after each screen full of the information?

1 Answers 6 Views

While working with MS-DOS, which command is used to display the contents of a file and pause the display after each screenful of information?

1 Answers 5 Views

Which command is used to display the subdirectory structure of the currently logged drive and pause the screen display after each screenful of information?

1 Answers 5 Views

Which command will display the CHAP authentication process as it occurs between two routers in the network?

1 Answers 4 Views

You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)