Riveted Joints MCQ
Test your knowledge with important Riveted Joints MCQ and their applications. These MCQs are beneficial for competitive exams too. Explore 30+ more Riveted Joints MCQs on Bissoy. Bissoy App
-
In a rivet joint thickness of the plate is t and the length of the margin is m. If the permissible shearing stress of the plate is τs, find the shear strength of the joint at the margin.
-
In single riveted, double strap butt joint, what will be that possible thickness of the cover plate/strap ts, if the thickness of the main plate is t?
-
For the plate of thickness t, which is in tension has permissible stress of σt, with pitch p, and rivet hole diameter d, find the tensile strength of the riveted joint.
-
When the pitch is p, rivet hole diameter is d, and the thickness of the plate is t, then what will be the area that resists the tensile force?
-
Lap joints are preferred for connecting tie bars in bridge structures and roof trusses.
-
If the thickness of the steel plates that are riveted is 9mm, what will be the diameter of the rivets used?
-
What will be the row pitch Pr, of the zig-zag riveting, when the pitch is given as p?
-
When the pitch of the rivet joints is p, what will be the row pitch Pr for chain riveting?
-
If the diameter of the rivet is d, then what is the margin?
-
If the diameter of the rivet is d, Find the pitch, that is usually considered in riveted joints.
-
Caulking and fullering are the process that makes riveted joints fluid tight and leak proof.
-
Quality checking of riveted joint is much expensive than that of welded joint.
-
In joining steel plate and asbestos, welding is preferred over riveting.
-
Riveting is not recommended for aluminium alloys.
-
Among punching and drilling, punching is safer.
-
Among punching and drilling, which is cheaper?
-
Two steel rods connected by cotter joint are subjected to 50 kN load each. What is the minimum diameter required of the rods? (Given: Yielding Stress= 400N/mm² ; Factor of Safety=6)
-
The amount by which the two rods to be joined are drawn together is called as?
-
In hot riveting the shank portion is subjected to compressive stress.
-
In hand riveting die is a part of hammer.
-
A rivet is specified as a 20mm rivet. What does it mean?
-
Which of the following isn’t a main part of rivet?
-
The flat ends of a boiler are prevented from bulging out and are strengthened by means of _________
-
In butt joint when two straps are used the thickness varies between _______ to ________ (T is the thickness of plate to be connected).
-
In butt joint when one strap is used the thickness varies between _______ to ________ (T is the thickness of plate to be connected).
-
In zigzag lap joint formation when P is the pitch between the rivets, the distance between the rows of rivets should not be less than _____
-
Width (L) of overlap of sheets is equal to ________ when d is the diameter of a rivet in case of single-riveted lap joint.
-
A joint is said to be double-riveted, triple riveted etc. accordingly to the number of sheets used.
-
In a lap joint, if the plates are connected to each other when the joint is made with only one row of rivets then it is called double-riveted lap joint.
-
Tearing of the plate between the edges of the plate and rivet-hole takes place when ____________