Width (L) of overlap of sheets is equal to ________ when d is the diameter of a rivet in case of single-riveted lap joint.

Width (L) of overlap of sheets is equal to ________ when d is the diameter of a rivet in case of single-riveted lap joint. Correct Answer 3d

For a lap joint, if the plates are made to connect using only one row of rivets then it is called single-riveted lap joint. The width of overlap L is equal to 3d when d is the diameter of rivet.
Bissoy MCQ

Related Questions

When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
In a lap joint, if the plates are connected to each other when the joint is made with only one row of rivets then it is called double-riveted lap joint.
A user type a content on 20 sheets, each sheet consist of 55 lines, and each line can have 66 characters. The content is again retyped on another set of sheets, these new sheets have 65 lines and each line can take 70 characters. Calculate the reduction in sheets ?
The expected efficiency of a single rivetted lap joint is of the order of 50%. If the thickness of the plate is increased four times, then the rivet diameter will have to be increased __________ times.
The diameter of the rivet hole is usually __________ the nominal diameter of the rivet.
In case of joint products, the main objective of accounting of the cost is to apportion the joint costs incurred up to the split off point. For cost apportionment one company has chosen Physical Quantity Method. Three joint products ‘A’, ‘B’ and ‘C’ are produced in the same process. Up to the point of split off the total production of A, B and C is 60,000 kg, out of which ‘A’ produces 30,000 kg and joint costs are Rs 3,60,000. Joint costs allocated to product A is.
In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)
A riveted joint in which every rivet of a row is opposite to other rivet of the outer row, is known as
A report consists of 20 sheets each of 55 lines and each such line consist of 65 characters. This report is reduced onto sheets each of 65 lines such that each line consists of 70 characters. The percentage reduction in number of sheets is closer to
The length of overlap of plates to be fillet welded in lap joint ____