Bissoy.com
Doctors Medicines MCQs Q&A

When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)

When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.) Correct Answer Gives the minimum angle between the two forces Fa and Fm

Related Questions

This are the following statements given regarding satellite’s motion a. A satellite in geostationary orbit lies in the same plane with equator b. A satellite in geosynchronous orbit lies in the same plane with equator c. A satellite in geostationary orbit does not lie in the same plane with equator, it is inclined at some angle from plane of equator d. A satellite in geosynchronous orbit does not lie in the same plane with equator, it is inclined at some angle from plane of equator Choose one of the following options
Consider the following statements: In case of helical gears, teeth are cut at an angle to the axis of rotation of the gears. 1) Helix angle introduces another ratio called axial contact ratio. 2) Transverse contact ratio is equal to axial contact ratio in helical gears. 3) Large transverse contact ratio does not allow multiple teeth to share the load. 4) Large axial contact ratio will cause larger axial force component Which of the above statements are correct?
According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through center of gravity (i.e. $$I$$P) is given by (where, A = Area of the section, $$I$$G = Moment of inertia of the section about an axis passing through its C.G. and h = Distance between C.G. and the parallel axis.)
According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through center of gravity (i.e. $${I_{\text{P}}}$$) is given by (where, A = Area of the section, $${I_{\text{G}}}$$ = Moment of inertia of the section about an axis passing through its C.G. and h = Distance between C.G. and the parallel axis.)
The maximum harbour depth below lowest low water is generally equal to
(i) loaded draft + 1.2 m when bottom is rock
(ii) loaded draft + 1.8 m when bottom is soft
(iii) loaded draft + 1.2 m when bottom is soft
(iv) loaded draft + 1.8 m when bottom is rock
If a disc has moment of inertia I about the axis which is tangential and in plane of the disc. then the moment of inertia about the axis which is tangential and perpendicular to its plane will be
If a disc has moment of inertia I about the axis which is tangential and in plane of the disc, then the moment of inertia about the axis which is tangential and perpendicular to its plane will be:
If any force is applied in the direction of the positive x-axis, and there are three different points in bending moment diagram on which the moment of this force is to be calculated. Then if these three points are on the positive side of the y-axis with varying distance, then what will be the direction of the moment caused by the force to the individual point?
Directions : In each of the following questions a statement is given, followed by two conclusions. Give answer :

Statement : Sachin's mother instructed him to return home by train if it rains heavily.

Assumptions :
I. Sachin may not be able to decide himself if it rains heavily.
II. The trains may ply even if it rains heavily.
In order to have a connecting rod equally strong in buckling about X-axis and Y-axis, the moment of inertia about X-axis should be __________ the moment of inertia about Y-axis.