Bissoy.com
Doctors Medicines MCQs Q&A

In single riveted, double strap butt joint, what will be that possible thickness of the cover plate/strap ts, if the thickness of the main plate is t?

In single riveted, double strap butt joint, what will be that possible thickness of the cover plate/strap ts, if the thickness of the main plate is t? Correct Answer ts = 3t/4

In double strap butt joint the thickness of the strap or the cover plate must be less than the thickness of the main plate. It is often considered as the 0.75 times the thickness of the main plate.

Related Questions

When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as ________ double cover butt joint.
When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as _______ double cover butt joint.
Why is double cover butt joint preferred over single cover butt joint or lap joint?
Consider the following statements regarding welded and riveted joints 1. Welded assemblies are tight and leak proof as compared with riveted assemblies. 2. Single-welded V-joint is less reliable than square butt joint. 3. Welding results in a thermal distortion of the parts, thereby inducing residual stresses. Which of the above statements is/are correct ?
Average thickness of double cover plate butt joint is 0.75 times that of main plate.
According to I.B.R., the efficiency of a double riveted butt joint with double cover straps of equal width should be
Two plates are joined by double strap butt joints with rivets arrangement as shown in the figure. Width of the plate is 300mm and diameter of rivets 30mm. The thickness of the plates can be taken as 20mm. Allowable stress in tension, shear and compression are 80 N/mm²,60 N/mm² and 160N/mm². If width of plate=80mm and diameter of rivets 10mm, then pitch will be?
Two plates are joined by double strap butt joints with rivets arrangement as shown in the figure. Width of the plate is 300mm and diameter of rivets 30mm. The thickness of the plates can be taken as 20mm. Allowable stress in tension, shear and compression are 80 N/mm²,60 N/mm² and 160N/mm². Calculate efficiency of the joint.
In butt joint when one strap is used the thickness varies between _______ to ________ (T is the thickness of plate to be connected).
Calculate the thickness of the strap required in longitudinal butt joint if pitch of the rivets is 150mm and diameter of rivets 30mm. Also thickness of plate is 20mm.