Related Questions

When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A steel bar of 20mm x 20mm square cross-section is subjected to an axial compressive load of 100kN. If the length of the bar is 1m and E=200GPa, then what will be the elongation of the bar?
Two plates are joined by double strap butt joints with rivets arrangement as shown in the figure. Width of the plate is 300mm and diameter of rivets 30mm. The thickness of the plates can be taken as 20mm. Allowable stress in tension, shear and compression are 80 N/mm²,60 N/mm² and 160N/mm². Calculate the shear resistance of 1 rivet along A-A.
Two plates are joined by double strap butt joints with rivets arrangement as shown in the figure. Width of the plate is 300mm and diameter of rivets 30mm. The thickness of the plates can be taken as 20mm. Allowable stress in tension, shear and compression are 80 N/mm²,60 N/mm² and 160N/mm². Calculate the tensile strength of rivet along A-A.
Two plates are joined by double strap butt joints with rivets arrangement as shown in the figure. Width of the plate is 300mm and diameter of rivets 30mm. The thickness of the plates can be taken as 20mm. Allowable stress in tension, shear and compression are 80 N/mm²,60 N/mm² and 160N/mm². Calculate the crushing resistance of 1 rivet.
In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia. of rivet d should be equal to
According to Indian standards, the diameter of rivet hole is made larger than the basic size of rivet by
A riveted joint in which every rivet of a row is opposite to other rivet of the outer row, is known as
In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)
The diameter of the rivet hole is usually __________ the nominal diameter of the rivet.