Tearing of the plate between the holes is taken when ________________________

Tearing of the plate between the holes is taken when ________________________ Correct Answer they are near to each other

Tearing of the plate between the holes takes place if they are very near to each other. Tearing of the plate between the edges of the plate and rivet-hole takes place if the hole is too near the edge.
Bissoy MCQ

Related Questions

In a punching press, the requirement is to punch 40 mm diameter holes in a plate having a thickness of 15 mm. The rate at which the holes should be punched is 30 holes/min. Energy requirement is of 6 N-m per mm2 of sheared area. If the punching takes time 1/10 of a second and the speed of the flywheel varies from 160 to 140 rpm, determine the mass of the flywheel having radius of gyration of 1 m.
Tearing of the plate between the edges of the plate and rivet-hole takes place when ____________
Mrs. Carson took a taxi to meet her three friends for lunch. They were waiting for her outside the restaurant when she pulled up in the car. She was so excited to see her friends that she left her tote bag in the taxi. As the taxi pulled away, she and her friends took notice of the license plate number so they would be able to identify the car when they called the taxi company.

#1 : The four women seem to agree that the plate starts out with the letter J.
#2 : Three of them agree that the plate ends with 12L.
#3 : Three of them think that the second letter is X, and a different three think that the third letter is K.

The four license plate numbers below represent what each of the four women thinks she saw. Which one is most likely the license plate number of the taxi?
In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia. of rivet d should be equal to
To avoid the tearing off the plate of an edge, the margin (i.e., the minimum distance from the centre of the rivet hole to the nearest edge of the plate) should be equal to
In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)
Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole and $${\sigma _{\text{t}}}$$ = Permissible tensile stress for plate material)
In order to avoid tearing off the plate at an edge, the distance from the center of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)
In a semiconductor it is observed that three-quarters of the current is carried by electrons and one quarters by holes. If the drift speed is three times that of the holes, what is the ratio of electrons to holes?
To effect a bond between two metal plates, 2.5 cm and 15 cm thick, heat is uniformly applied through the thinner plate by a radiant heat source. The bonding must be held at 320 K for a short time. When the heat source is adjusted to have a steady value of 43.5 k W/m2, a thermocouple installed on the side of the thinner plate next to source indicates a temperature of 345 K. Calculate the temperature gradient for heat conduction through thinner plate. In the diagram, the upper plate is 2.5 cm thick while the lower is 15 cm thick.