Bissoy.com
Doctors Medicines MCQs Q&A

In order to avoid tearing off the plate at an edge, the distance from the center of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)

In order to avoid tearing off the plate at an edge, the distance from the center of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm) Correct Answer 1.5 d

Related Questions

In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)
In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia. of rivet d should be equal to
To avoid the tearing off the plate of an edge, the margin (i.e., the minimum distance from the centre of the rivet hole to the nearest edge of the plate) should be equal to
A riveted joint may fail by 1. tearing of the plate at an edge 2. tearing of the plate across a row of rivets 3. shearing of rivets Which of the above are correct?
Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole and $${\sigma _{\text{t}}}$$ = Permissible tensile stress for plate material)
The distance between the center of a rivet hole to the nearest edge of plate, is called
Tearing of the plate between the edges of the plate and rivet-hole takes place when ____________
Statement: Syrian President Bashar al-Assad has revealed during an interview that a direct clash between the US and Russia in Syria was narrowly avoided "by the wisdom of the Russian leadership".  Which of the following objection(s) might be a probable reason(s) for such a revelation by Syrian President Bashar al-Assad? I. Adding that Syria needs Russian support, Assad said, "At the same time we need to avoid the American foolishness in order to be able to stabilise our country". II. Adding that Syria needs American support, Assad said, "At the same time we need to avoid the American foolishness in order to be able to stabilise our country". III. Adding that Syria needs Russian support, Assad said, "At the same time we need to avoid the Russian foolishness in order to be able to stabilise our country". IV. Adding that Syria needs American support, Assad said, "At the same time we need to avoid the Russian foolishness in order to be able to stabilise our country".
Which of the following assumptions are made in the design of rivet joints? A. Rivets are stressed equally B. Stress in plate is maximum at mid-width C. Rivet hole is completely filled by rivet D. Friction between plates is neglected
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)