Related Questions

The velocity of piston in a reciprocating steam engine is given by (where $$\omega $$ = Angular velocity of crank, r = Radius of crank pin circle, $$\theta $$ = Angle turned by crank from inner dead center and n = Ratio of length of connecting rod to the radius of crank)
A $$\omega {\text{r}}\left( {\sin \theta + \frac{{\sin 2\theta }}{{\text{n}}}} \right)$$
B $$\omega {\text{r}}\left( {\cos\theta + \frac{{\cos2\theta }}{{\text{n}}}} \right)$$
C $${\omega ^2}{\text{r}}\left( {\sin \theta + \frac{{\sin 2\theta }}{{\text{n}}}} \right)$$
D $${\omega ^2}{\text{r}}\left( {\cos\theta + \frac{{\cos2\theta }}{{\text{n}}}} \right)$$
The connecting rod is attached to the piston by the
A Cap bolt
B Piston pin
C Cap roller bearing
D Rod cap
The primary unbalanced force due to inertia of reciprocating parts in a reciprocating engine is given by (where m = Mass of reciprocating parts, $$\omega $$ = Angular speed of crank, r = Radius of crank, $$\theta $$ = Angle of inclination of crank with the line of stroke and n = Ratio of the length of connecting rod to radius of crank)
A $${\text{m}}{\omega ^2}{\text{r}}\sin \theta $$
B $${\text{m}}{\omega ^2}{\text{r}}\cos \theta $$
C $${\text{m}}{\omega ^2}{\text{r}}\frac{{\sin 2\theta }}{{\text{n}}}$$
D $${\text{m}}{\omega ^2}{\text{r}}\frac{{\cos2\theta }}{{\text{n}}}$$
The secondary unbalanced force due to inertia of reciprocating parts in a reciprocating engine is given by (where m = Mass of reciprocating parts, $$\omega $$ = Angular speed of crank, r = Radius of crank, $$\theta $$ = Angle of inclination of crank with the line of stroke and n = Ratio of the length of connecting rod to radius of crank)
A $${\text{m}}{\omega ^2}{\text{r}}\sin \theta $$
B $${\text{m}}{\omega ^2}{\text{r}}\cos \theta $$
C $${\text{m}}{\omega ^2}{\text{r}}\frac{{\sin 2\theta }}{{\text{n}}}$$
D $${\text{m}}{\omega ^2}{\text{r}}\frac{{\cos2\theta }}{{\text{n}}}$$
In order to have a connecting rod equally strong in buckling about X-axis and Y-axis, the moment of inertia about X-axis should be __________ the moment of inertia about Y-axis.
A Equal to
B Twice
C Three times
D Four times
What type of bearing is used for main bearings and connecting rod bearings?
A Ball bearings
B Plain bearings
C Needle roller bearing
D Taper roller bearing
For the same length of stroke and speed of crankshaft, the piston speed for a double acting steam engine is _________ the piston speed of single acting steam engine.
A Equal to
B Twice
C Three times
D Four times
A connecting rod is designed as a
A Long column
B Short column
C Strut
D All of these
Connecting rod is, usually, made from
A Low carbon steel
B High carbon steel
C Medium carbon steel
D High speed steel
Connecting rod is usually made of
A Aluminium
B Low carbon steel
C Medium carbon steel
D High carbon steel

Next steps