Related Questions

The static tooth load should be __________ the dynamic load.
A Equal to
B Less than
C Greater than
D None of these
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A Is at the maximum distance from CG of the rivet group
B Is at the minimum distance from CG of the rivet group
C Gives the maximum angle between the two forces Fa and Fm
D Gives the minimum angle between the two forces Fa and Fm
A certain dentist specializes in implanting gold and silver teeth in his patients mouths .He charges $ 650 for a gold tooth an $ 325. for a silver tooth. If his told fees for implanting gold and silver teeth last week were $ 15, 925 in total and he implanted five more gold teeth that silver teeth, how many teeth in total did he implant over the week?
A 33
B 32
C 31
D 34
The radial distance of a tooth from the pitch circle to the bottom of the tooth is called
A dedendum
B addendum
C clearance
D working depth
The radial distance from the top of a tooth to the bottom of a tooth in a meshing gear, is called
A dedendum
B addendum
C clearance
D working depth
In _________ operation, the cutting force is maximum when the tooth begins its cut and reduces it to minimum when the tooth leaves the work.
A Up milling
B Down milling
C Face milling
D End milling
The flank of the tooth is the surface of the tooth __________ the pitch surface.
A Above
B Below
C At
D None of these
The difference between the tooth space and the tooth thickness as measured on the pitch circle, is called
A Working depth
B Clearance
C Backlash
D Face width
The radial distance of a tooth from the pitch circle to the top of the tooth is called
A Addendum
B Dedendum
C Clearance
D Working depth
In a plain milling cutter, the chip space between the back of one tooth and the face of the next tooth is called
A Face
B Fillet
C Gash
D Land

Next steps