Related Questions

In a plain milling cutter, the portion of the gash adjacent to the cutting edge on which the chip impinges is called
A Face
B Fillet
C Land
D Lead
The cutting force in up milling ________ per tooth movement of the cutter.
A Is zero
B Is maximum
C Decreases from maximum to zero
D Increases from zero to maximum
Read the following passage carefully and then choose the right word to complete the sentence that follows. Rockets are very expensive as it can be used only once. Appled scientists have therefore develped a reusable space craft called a space shuttle which takes off like a rocket; however, does no get destroyed as it returns to earth. It can also be used to lunch satellired into space, retrieve them from space if any repairing os required and allow around 8 scientists to crryout experiments in space. The space shuttle does not get.
A flattened
B enlarged
C ruined
D developed
Six arms negotiators -- M,O,P,R,S and T-- are to be seated at a round table to discuss disarmament. There are exactly six chairs around the table. Each negotiator sits facing the center of the table and is directly opposite a negotiators across the table.The seating arrangement is subject to the following restrictions : T cannot sit next to P;S cannot sit next to M;R must sit next to M. If T sits next to M and S sits next to R, which of the other negotiators must sit next to s ?
A M
B O
C P
D R
The difference between the tooth space and the tooth thickness as measured on the pitch circle, is called
A Working depth
B Clearance
C Backlash
D Face width
In a milling operation, two side milling cutters are mounted with a desired distance between them so that both sides of a workpiece can be milled simultaneously. This set up is called
A Gang milling
B Straddle milling
C String milling
D Side milling
Six arms negotiators -- M,O,P,R,S and T-- are to be seated at a round table to discuss disarmament. There are exactly six chairs around the table. Each negotiator sits facing the center of the table and is directly opposite a negotiators across the table.The seating arrangement is subject to the following restrictions : T cannot sit next to P;S cannot sit next to M;R must sit next to M. If M sits next to P which of the following is a complete and accurate list of those who can sit next to P on P's other side ?
A O
B O,S
C O,S,R
D R,S,T
In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be
A Doubled
B Halved
C Quadrupled
D Unchanged
The Central Processing Unit is an embeded chip that acts as the 'brains' of a computer. What Intel chip was used in the Altair (the first real personal computer)?
A 6502
B 8080
C 6400
D 8286
In down milling, the thickness of chip is
A Minimum at the beginning of the cut and maximum at the end of the cut
B Maximum at the beginning of the cut and minimum at the end of the cut
C Uniform throughout the cut
D None of these

Next steps