Bissoy.com
Doctors Medicines MCQs Q&A

In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be

In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be Correct Answer Doubled

Related Questions

In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90°, the shear angle in degree is
If t1 denotes the uncut chip thickness and t2 denotes cut chip thickness ratio then, which of the following equation is correct about chip thickness ratio ‘r’?
In an orthogonal machining operation : Uncut thickness = 0.5 mm Cutting speed = 20 m/min Rake angel = 150 Width of cut = 5 mm Chip thickness = 0.7 mm Thrust force = 200 N Cutting force = 1200 N The values of shear angle and shear strain, respectively, are
A single-point cutting tool with 120C rake angle is used to machine a steel work-piece. The depth of cut, i.e., uncut thickness is 0.81 mm. The chip thickness under orthogonal machining condition is 1.8 mm. The shear angle is approximately
Consider the following statements for a power shovel:
(i) Output can be increased by reducing the angle of swing for a given depth of cut.
(ii) For a given angle of swing, output will be maximum at optimum depth of cut.
(iii) Output can be increased by keeping the depth of cut less than optimum depth.
(iv) Output can be increased by increasing the size of shovel.
In a single point turning tool, the side rake angle and orthogonal rake angle are equal. ϕ is the principal cutting edge angle and its range is 000. The chip flows in the orthogonal plane. The value of ϕ is closest to
Student A rub solid baking soda on dry litmus paper, B rub metal oxide on dry litmus paper, C dip litmus paper in vinegar, D dip litmus paper in aqueous solution of baking soda. The observations were made by student A, B, C, and D should be- Student Effect on dry red litmus paper Effect on dry blue litmus paper A Color Changed to blue No change B No change Color changed to red C No change Color changed to red D Color Changed to blue       Color changed to red The correct observation was made by the student
If the following mathematical signs are changed as given below, then select the option which represents the correct equation. ÷ is changed to + × is changed to - + is changed to × - is changed to ÷
Last year, there were three sections in a competitive exam. Out of them 33 students cleared the cut-off in Section A, 34 students cleared the cut-off in Section B and 32 students cleared the cut-off in Section C. 10 students cleared the cut-off in section A and section B, 9 cleared the cut-off in section B and section C and 8 cleared the cut-off in section A and section C. The number of students who cleared only one section was equal and was 21 for each section. How many students cleared all the three sections?
If the ratio of GVF depth to normal depth and the ratio of critical depth to normal are equal to 0.5, calculate the rate of change of depth if the bed slope of the channel is 1 in 1300.