Related Questions

In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be
A Doubled
B Halved
C Quadrupled
D Unchanged
In oblique cutting system, the cutting edge of the tool
A May clear the width of the workpiece
B May or may not clear the width of the workpiece
C May not clear the width of the workpiece
D Should always clear the width of the workpiece
The orthogonal projection of the perspective centre on a tilted photograph, is called
A Nadir
B Isocenter
C Principal point
D Plumb point
When cutting and pasting, cutting section is temporarily stored in
A Dashboard
B Hard drive
C Diskette
D Clipboard
When cutting ans pasting , cutting section is temporarily stored in __
A Dashboard
B hard drive
C diskette
D clipboard
when cutting and pasting, cutting section is temporarily stored in __
A Dashboard
B Hard drive
C Diskette
D Clipboard
When cutting and pasting , cutting section is temporarily stored in -
A Dashboard
B Hard drive
C Diskette
D Clipboard
When cutting and pasting, cutting section is temporarity stored in-
A Dashboard
B Hard Dive
C Clipboard
D Pointer
In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:
A Removed section
B Revolved section
C Auxiliary section
D Partial section
As the cutting speed increases, the tool cutting forces
A Remain constant
B Increases
C Decreases
D First increases and then decreases

Next steps