In oblique cutting system, the cutting edge of the tool

A May clear the width of the workpiece
B May or may not clear the width of the workpiece
C May not clear the width of the workpiece
D Should always clear the width of the workpiece

Correct Answer: May not clear the width of the workpiece

In Oblique cutting, cutting edge travels, making an angle with the normal of cutting edge.In oblique cutting system, the cutting edge of the tool May not clear the width of the workpiece
Bissoy MCQ
#Mechanical Engineering #Manufacturing And Production Technology

Related Questions

In oblique cutting of metals, the cutting edge of the tool is
A Perpendicular to the workpiece
B Perpendicular to the direction of tool travel
C Parallel to the direction of tool travel
D Inclined at an angle less than 90° to the direction of tool travel
In oblique cutting system, the maximum chip thickness
A occurs at the middle
B may not occur at the middle
C depends upon the material of the tool
D none of the mentioned
Which of the following statement is correct for oblique cutting system?
A The cutting edge is inclined at an angle less than 90° with the normal to the velocity of the tool
B Frequently, more than one cutting edges are in action
C The chip flows on the tool face at an angle less than 90° with the normal on the cutting edge
D All of the above
When the cutting edge of the tool is dull, then during machining
A Continuous chips are formed
B Discontinuous chips are formed
C Continuous chips with built-up edge are formed
D No chips are formed
The width of cutting edge of a parting off tool varies from
A 3 to 12 mm
B 5 to 20 mm
C 8 to 30 mm
D 15 to 40 mm
Larger end cutting edge angle _________ tool life.
A Increases
B Decreases
C Does not effect
D None of these
In machining metal, cutting force at the cutting edge is measured by a
A Wattmeter
B Dynamometer
C Hydrometer
D Pyrometer
The angle made by the face of the tool and the plane parallel to the base of cutting tool is called
A Rake angle
B Cutting angle
C Clearance angle
D Lip angle
As the cutting speed increases, the tool cutting forces
A Remain constant
B Increases
C Decreases
D First increases and then decreases
If the length of a edge of cube X is thrice the length of an edge of cube Y, What is the ration of the volume of cube Y to the volume of cube X?
A 1/2
B 1/4
C 1/6
D 1/8

Next steps