Bissoy.com
Doctors Medicines MCQs Q&A

In oblique cutting system, the maximum chip thickness

In oblique cutting system, the maximum chip thickness Correct Answer may not occur at the middle

In orthogonal cutting, maximum chip thickness occurs at the middle but in oblique cutting, the maximum chip thickness may not occur at the middle.

Related Questions

If t1 denotes the uncut chip thickness and t2 denotes cut chip thickness ratio then, which of the following equation is correct about chip thickness ratio ‘r’?
In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be
Thickness of 8 tyres L, M, N, O, P, Q, R and S is compared. Thickness of no two tyres is same. Thickness of N is more than L but less than 6 tyres. Thickness of O is more than M but less than Q. Thickness of P is less than only two tyres. Thickness of Q is not more than P. Which of the following statement is not correct?
In an orthogonal machining operation : Uncut thickness = 0.5 mm Cutting speed = 20 m/min Rake angel = 150 Width of cut = 5 mm Chip thickness = 0.7 mm Thrust force = 200 N Cutting force = 1200 N The values of shear angle and shear strain, respectively, are
The chip select logic for a certain DRAM chip in a memory system design is shown below. Assume that the memory system has 16 address lines denoted by A15 to A0. What is the range of addresses (in hexadecimal) of the memory system that can get enabled by the chip select (CS) signal?
Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
Chip flow velocity during machining process is 0.2m/s with chip thickness ratio of 0.6. What is the value of cutting velocity?
Chip flow velocity during machining process is 1.2m/s with chip thickness ratio of 0.6. What is the value of cutting velocity?
In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90°, the shear angle in degree is
In oblique cutting system, the cutting edge of the tool