When cutting and pasting, cutting section is temporarity stored in-

A Dashboard
B Hard Dive
C Clipboard
D Pointer

Correct Answer: Clipboard

Bissoy MCQ
#সাধারণ জ্ঞান #পিএসসি ও অন্যান্য নিয়োগ পরীক্ষা #কর্ণফুলী গ্যাস ডিস্ট্রিবিউশন কোম্পানী লিমিটেড | সহকারী ব্যবস্থাপক(সাধারণ)| 4-12-2021

Related Questions

When cutting and pasting, cutting section is temporarily stored in
A Dashboard
B Hard drive
C Diskette
D Clipboard
when cutting and pasting, cutting section is temporarily stored in __
A Dashboard
B Hard drive
C Diskette
D Clipboard
When cutting and pasting , cutting section is temporarily stored in -
A Dashboard
B Hard drive
C Diskette
D Clipboard
When cutting ans pasting , cutting section is temporarily stored in __
A Dashboard
B hard drive
C diskette
D clipboard
Ruby Is heated It — temporarity loses its colour
A do
B will
C has
D often
Read the paragraph and answer the question-photosynthesis is a process in which radiant energy from sun is stored as chemical energy , which in turn is used to decompose carbon dioxide and water. The product of their decomposition are recombined into a new compound which successively builds, up into more and more complex organic substances like sugars, starches and cellulose that comprise the plant.The word stored in the paragraph is closest in morning to
A specified
B retained
C converted
D discovered
Semiconductor memory device in which stored data will remain permanently stored as long as power is supplied is --
A dynamic memory device
B storage device
C flash device
D static memory device
The strain energy stored in a body, when suddenly loaded, is __________ the strain energy stored when same load is applied gradually.
A Equal to
B One-half
C Twice
D Four times
In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:
A Removed section
B Revolved section
C Auxiliary section
D Partial section
In metal cutting, use of low feeds and high cutting speeds is desired when the objective is
A High metal removal rate
B Dry machining
C Use of soft cutting tool
D Surface finish

Next steps