Related Questions

A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
A Architectural
B Civil
C Mechanical
D Process piping
How can the drafter prevent Auto-CAD from placing or stacking another center mark on a circle when adding a diameter dimension to it?
A Explode the dimension and then erase the center mark
B Use the Properties dialog box to turn off the center mark of the dimension
C It can't be done
D Use the trim tool to take away the stacked center mark
When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
A Half
B Quarter
C Full
D Broken out
A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
A Offset
B Half
C Whole
D Broken out
By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
A Half
B Whole
C Revolved
D Broken out
In developing a multi-view drawing, the drafter can use a ________ line to help locate the top and right side views.
A Object
B Hidden
C Dimension
D Miter
In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.
A Leave the view as is
B Eliminate the view
C Use the left view instead
D None of the above
Before starting an isometric drawing in Auto-CAD the drafter needs to ________.
A Set the grid to isometric
B Set the current layer to Def-points
C Turn Object Snap off
D Turn Ortho off
In order to create an accurate assembly drawing the drafter should create the ________ drawings first.
A Detail
B Title block
C Parts list
D Isometric
Inserting blocks into a drawing file usually requires exacting placement. The drafter should insure that ________ is turned on.
A O Snaps
B Ortho
C Grid
D Dynamic Input

Next steps