Related Questions

A drafter who develops technical drawings of a highway overpass would most likely be a ________ drafter.
A Architectural
B Civil
C Mechanical
D Process piping
Radius of circle center 0 is 3 times the radius of circle center C. Angle ACB -A angle POQ. If the shaded are of circle C is 2 then what is the area of then shaded part of circleO?
A 36
B 9
C 12
D 18
To avoid having to dimension to a hidden feature the drafter can utilize a ________ section.
A Whole
B Half
C Broken out
D All of the above
ABCD is a square of side 10. AFC is an are of a circle with the center at D and radius 10. AGC is an are of a circle with the center at B and radius 10. Find the area of AFCG/
A 50 -100pie
B 25 -100 pie
C 100-25 pie
D 100-50pie
In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct iso-plane has been selected by scrolling through the iso-planes using the ________ key.
A F1
B F3
C F5
D F8
In the circle below, if 0 is the center of the circle, What fractin of the circle is shaded ?
A 112th
B 110th
C 18th
D 16th
In the picture area of the square ABCD is 196 square miles.O is the center of the circle of the circle.What will be the area of the circle in square miles ?
A 100π
B 49π
C 144π
D 64π
The radius of circle A is r, and the radius of circle B is 3/4r. What is the ratio of the area of circle A to the area of circle B?
A 16 to 9
B 9 to 16
C 1 to 4
D 4 to 3
When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
A Half
B Quarter
C Full
D Broken out
Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?
A Use the Modify tool to clean up the extension lines
B Use the Tolerance tool to clean up the extension lines
C Use the Break tool to clean up the extension lines
D Use the stretch tool to clean up the extension lines

Next steps